Solarbio Formaldehida Dehidrogenase (FDH) Kit Uji Aktivitas (Sampel Hewan)

Product Information

Nomor Katalog: BC4980

Spesifikasi: 50T/48S

Komponen Perangkat

• Extraction Solution: 60 mL x 1 botol, store at 2-8°C
• Reagent One: 35 mL x 1 botol, store at 2-8°C
• Reagent Two: Powder x 2 vials, store at -20°C
• Reagent Three: Powder x 2 vials, store at 2-8°C
• Reagent Four: 3 mL x 1 botol, store at 2-8°C

Solution Preparation

1. Reagen II: Menambahkan 0.25 mL distilled water before use. Unused reagents should be stored at -20℃ for two weeks.
2. Working solution of Reagent II: According to the amount required for the test, prepare the Working solution according to the ratio of Reagent II (μL): Air sulingan (μL) =1:29, and prepare the reagents when it will be used. The Working solution of Reagent II should be used up on the same day if it is prepared on the same day.
3. Reagen III: Menambahkan 1.5 mL distilled water before use. Aduk rata. Unused reagents should be stored at -20℃ for two weeks

Deskripsi Produk

Formaldehyde dehydrogenase exists in most prokaryotes and all eukaryotes. It is an oxidoreductase that converts formaldehyde. Formaldehyde dehydrogenase can catalyze formaldehyde and NAD+ to produce NADH. The absorbance at 340 nm will increase. By measuring the change at 340nm, the activity of formaldehyde dehydrogenase can be calculated.

Notes:

1. It is recommended to select 2-3 samples with expected large differences for pre-experiment before the experiment. If the sample absorbance is not within the measurement range, it is recommended to dilute or increase the sample volume for detection.

Required Instruments and Supplies:

• UV spectrophotometer
• Low-temperature centrifuge
• Constant temperature incubator/water bath
• Adjustable pipette
• 1 mL kuvet kuarsa
• Mortar/homogenizer
• Ice and distilled water

Operation Steps:

SAYA. Sample Treatment (the amount of sample to be tested can be adjusted appropriately, and the specific ratio can be referenced)

• Jaringan: According to the ratio of animal tissue weight (G): extraction solution volume (ml) = 1:5~10 (it is recommended to weigh 0.1 g of animal tissue and add 1 mL of extraction solution), homogenize in an ice bath, sentrifugasi di 8000 G, 4°C untuk 10 menit; ambil supernatannya (if the supernatant is not clear enough, it is recommended to repeat the above centrifugation steps) and place it on ice for testing.

II. Langkah Penentuan

1. Preheat the UV spectrophotometer for at least 30 menit, adjust the wavelength to 340 nm, dan nol dengan air suling.
2. Preheat Reagent One and Reagent Four at 37°C for 10 minutes before use.
3. In a 1 mL kuvet kuarsa, menambahkan 100 μL of sample, 550 μL of Reagent One, 250 μL of Reagent Two working solution, 50 μL of Reagent Three, Dan 50 μL of Reagent Four in sequence. Mix thoroughly immediately and determine the absorbance A1 at 340 nm for 20 detik. Place it in a 37°C water bath or incubator for 5 minutes to react, quickly remove it and wipe it dry, and determine the absorbance A2 at 5min20s. Record the absorbance A1 at 340 nm for 20 seconds and the absorbance A2 after 5 menit. Calculate ΔA = A2 – A1.

AKU AKU AKU. Calculation of FDH Activity in Animal Tissue

1. Calculation based on sample protein concentration:

Unit definition: One unit of enzyme activity is defined as the amount of enzyme that catalyzes the production of 1 nmol of NADH per minute per mg of tissue protein.